![]() |
RMC WAH GUTS NO LONGER AVAILABLE Upgrade your existing "traditional" non-RMC wah with the RMC WAH GUTS. Everything but the Italian switch, Switchcraft jacks, and Karmaflux inductor is New Old Stock. These NOS kits are NOT fuzz-friendly - they are built up from pre-FFT/FWR boards. They will fit "normal" wah shells - Thomas Organ Co., Dunl*p, Dunl*p-built brands (V*x V-847 & V-848, B*dda [not the S*nbeam steam iron model]), and even the shells that Sm*llbear sells. I can include a power supply jack that fastens on the inside of the wah shell if you already have a 1/2" hole or can drill one and can then solder the wires - the related filter components will already be on the circuit board even if they're not required/requested. I figure I should make the power supply jack as easy to add, even in the future, as possible. As in the above photo, I can install a pre-wired and soldered power jack that fastens on the outside of the wah shell if you want a power supply jack but can't solder. If you'd rather not drill a hole in your wah shell for a power jack then I can keep the GUTS battery powered only. The RMC WAH GUTS is NOT RoHs Compliant and can ONLY be sold within the USA. Sound - A bit more clean and clear than my production models as the GUTS kit doesn't run as "hot" as my production stuff. The whole kit has been voiced to get along well with single coils, P-90's, and humbuckers. Strong, clear bottom end that doesn't vanish at heel down, a fairly rapid transition through the mids to the top end which is not sharp and spikey. While I prefer to use my Karmaflux inductor because it is EMI/hum resistant, I can build the Guts kit with a (hum sensitive) halo inductor if requested. The RMC WAH GUTS DIY kit is available now. The delivered (USA ONLY) cost is $135. Email Geoffrey for purchase information.
Back to RMC HOME |
WHAT'S
HAPPENING |
|